|
Marvelous Memory Frame Designed by Peggy Budfuloski
Materials:
LuminArte Materials:
Radiant Rain Pure Color Concentrate Daubers: large assortment of colors with extra mister tops.
Radiant Rain Misters: large assortment of colors
Polished Pigments Pure Mica: Solar Gold, Copper, I-Green: I-Blue: I-Violet- I-Gold-I-Red
Polished Pigments Pure Color: Stargazer, Key Lime, Pink Grapefruit, Lemondrop
Walnut Hollow:
Paper Mache Frame
Ranger:
Adirondack Acrylic Black Paint Dabber
Non-Stick Craft Sheet
Glossy Accents
Lumina Clay-air dry polymer clay -1 pack
Amaco:
Pasta Machine-largest setting
Clay tools-roller wheel
General Products:
Black permanent marker with chisel edge
Favorite stamps with deep edge to stamp nice grooves in clay
Fast Grab Glue
Acrylic Crystal Clear-glossy spray
Chisel edge Paint Brush (throw away)
Paper towels
Scissors
6 8oz. paper cups
Heat gun
Step 1
Take clay out of package and work fairly quickly (do not condition clay unless hand rolling-roll to 1/8 of inch)
Run through pasta machine and gently pull apart to get full length
 
Step 2
Cut length wise in 1inch strips. Then cut into 4 inch or longer strips
 
Step 3
Place paper towels down and gently stack all of the cut clay together
Lay 2-3 strips of cut clay on a paper towel and stamp all over with an assortment of stamps
 
Set aside and do 2-3 more strips until done. Once all the clay is done let it dry for 20-30 minutes
Step 4
Paint frame with Ranger Black Dabber paint. Paint back of frame as well
Step 5
Lay Ranger Craft Sheet paper down and a layer of paper towel. Work with one clay strip at a time. Spray half of the strip with LuminArte Radiant Rain Spray Mister and the other half with Radiant Rain Dauber with mister top replacing the dauber top
Step 6
Dry with heat gun (do not boil paint) going from one direction to the other to create a blend of colors in the middle of strip. Colors will appear darker; however, this will change when finish is applied
Step 7
Rub several LuminArte mica colors and pure pigment colors on surface of clay with your fingers, moving into the grooves of the stamp
 
Step 8
Spray with clear fixative and let dry. Place frame in front of you and cut strips in a Quilt Pattern or puzzle. Design your layout.
Step 9
Use your permanent marker and do all the edges of the clay pieces. Put them back in your original layout as you complete each one
Step 10
Apply glue to the back of a clay piece (distribute glue evenly). Continue until all pieces are done
Step 11
Spray clear fixative onto finished 'quilt' pieces
 
Step 12
After pieces are dry, put picture into frame
Step 13
Then squeeze the liquid fixative, Glossy Accent from Ranger onto the entire piece, including the picture
Step 14
Spread glossy sealant with ‘throw away’ brush
Allow to day completely in safe area for 24 hours
Your finished frame with picture and glossy surface
|
